\
  The most prestigious law school admissions discussion board in the world.
BackRefresh Options Favorite

Knife bros, cum ITT to rate my new knife sharpener

It's a work in progress - I'm going to be machining a clamp ...
Topaz electric church building dingle berry
  05/05/21
...
Topaz electric church building dingle berry
  05/06/21
180. Can you make me 1?
Shivering bronze idiot
  05/13/21


Poast new message in this thread



Reply Favorite

Date: May 5th, 2021 11:46 PM
Author: Topaz electric church building dingle berry

It's a work in progress - I'm going to be machining a clamp from aluminum but started with 3D printed PETG so that I could figure out the dimensions and everything before getting into metalwork - but even with a plastic clamp it's absolutely the easiest, most consistent sharpening system I've ever used. It took about 5 minutes to put the best edge I've ever seen on a knife on my pocket knife.

Here it is: https://imgur.com/a/JZKvQjR

I modeled after the Wicked Sharp sharpening system, which range from $350 to well over $1000.

https://wickededgeusa.com/products/commercial-series

(http://www.autoadmit.com/thread.php?thread_id=4827572&forum_id=2#42409749)



Reply Favorite

Date: May 6th, 2021 12:22 AM
Author: Topaz electric church building dingle berry



(http://www.autoadmit.com/thread.php?thread_id=4827572&forum_id=2#42410013)



Reply Favorite

Date: May 13th, 2021 5:36 PM
Author: Shivering bronze idiot

180. Can you make me 1?

(http://www.autoadmit.com/thread.php?thread_id=4827572&forum_id=2#42456578)